Installation och förberedelser:
1. Prepare the rock drilling chamber, and its specifications can be determined according to the drilling method. Generally, when excavating horizontal holes, the chamber height is 2.6-2.8 meters. When excavating upward, downward, or inclined holes, the chamber width is 2.5 meters and the height is 2.8-3 meter.
2. Lead gas- och vattenledningar, belysningslinjer osv.
3. According to the design requirements of the hole, firmly erect the pillar. The upper and lower ends of the pillar shall be padded with wood plates, and the horizontal shaft and snap ring shall be installed on the pillar according to a certain height and direction. The machine shall be lifted by the hand winch, fixed on the pillar according to the required angle, and then the hole direction of the borr ska justeras .
Inspektion före läxor:
1. När du startar arbetet, kontrollera noggrant om gas- och vattenledarna är säkert anslutna och om det finns några luft- eller vattenläckor .
2. Kontrollera om oljeinjektorn är fylld med motorolja .
3. Kontrollera om skruvarna, muttrarna, lederna osv.
Borroperationsförfarande:
When opening the hole, start the motor first, and after the transfer is normal, turn the push handle of the manipulator. Give it appropriate propulsion force, and then turn the handle that controls the impactor to the working position. After rock drilling work, the water valve can be opened to maintain an appropriate ratio of gas water mixture. Perform normal rock drilling work. When the Att främja arbetet får borrstången att röra sig och kollidera med borrstånghållaren, en borrstång borras . för att stoppa driften av motorn och stoppa luften och vattenförsörjningen till Impactor, sätt in gaffeln i borrstången för borrstången 5} upprepning. operation .
